7845GSM/7845GSMCN Installation and Setup Guide
3-10
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
8
Exit Prog. Mode?
(Y/N)_
✔ ✔
[Y], [N]
[ESC]
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph
in this Section.
9
Device Mode
(ECP)_
✔ ✔
• ECP
• Zone Trig.
• 4204 Emu
• Two 4204s
Press the [space] key to scroll through the modes of
operation.
Press [ENTER] to select the mode of operation.
See Table 3 for ECP mode programming.
Important Information Regarding Primary Account (Questions 10-12)
Account information is provided by the central station administrator.
10
Primary City ID
(??)_
✔
✔
[01-99]
Enter the 2-digit primary city ID, 01-99 (decimal).
11
Primary CS ID
(???)
✔
✔
[01-FE]
Enter the 2-digit primary central station ID
number, 01-FE (HEX).
12
Primary Sub ID
(????)
✔ ✔
[0001-9999]
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
13
Device Address
(12)_
✔
[01-15]
The 7845GSM communicates with the control
panel as a 4204 relay module. Enter the
appropriate address. For VISTA-10P and
FA130CP Series control panels, this must be
address 12. For other controls, see the control
panel’s Installation and Setup Guide.
NOTES:
1. The 4204 protocol limits address range to 01-15.
If using 2-4204 mode, the 7845GSM assigns the
second 4204 to the next higher device address
(e.g., if entering address 12 for the first 4204,
then address 13 is automatically assigned to the
second 4204 module). Program the control panel
accordingly.
2. The device address(es) must be unique from the
"Direct Wire Addr" entered in Prompt 15 and
any other address used on the control panel.
14
Enable DW Y/N
(N)_
✔
[Y], [N]
Applies only to VISTA-128BP/250BP and FBP
Series controls, and FA1660C and 1700C Series
controls.
Enables Direct Wire Downloading over GSM.
If [N], skip to Prompt 16: "Supervision."
15
Direct Wire Addr
(28)_
✔
[01-30]
When using Direct Wire downloading, the
7845GSM communicates with the panel as an
alpha keypad to initiate the direct wire download
session. Enter the appropriate device address.
NOTES:
1. This address must also be programmed as an
alpha keypad in the control panel (Device
Programming Mode). DO NOT connect an
actual keypad (or any other device) assigned to
this address.
2. This address must be unique from the "Device
Address" entered in Prompt 13, and cannot
equal that device address plus 1 (one) if using
2-4204 mode.
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels